NIMASO Glass Film for iPad 10.2 (7th-9th Generation) High Gloss with Guide Frame, Pack of 1

Simple explanation of pasting procedure

1. Clean your screen with a full range of accessories.
2. Fit the guide frame securely into the main body.
3. As shown in the image, peel off about half of the protective sticker, and while holding the front camera to prevent the iPad from moving, place the glass film firmly against the front camera side of the guide frame.
4. To prevent it from shifting position, lightly press the glass on the front camera side and lower it while peeling off the remaining protective sticker.
5. Remove the guide frame from the corner.

* When removing the protective sticker, make sure to peel it off with the side that will be attached to the LCD facing down.

* Please stick it in a place with little wind and dust, such as a bathroom. If dust gets in, you can lift the corner closest to the dust up to the dust and remove it using the included dust removal sticker or cellophane tape.

*To prevent the film from floating when reapplied, be careful not to touch the adhesive surface when removing the film.

*If any small air bubbles or bubbles appear during application, you can remove them by wrapping a cloth around your finger and pushing them out little by little. If that doesn't solve the problem, you can peel off the glass film and apply it again. (You can also remove them by carefully pushing the film up from the edge to the air bubbles or bubbles with your fingernail, then slowly lowering it and applying it again.)

*This product is made of extremely thin tempered glass material. If you apply excessive force before or during application, or bend it more than necessary, it may break.